AMC PROXIMITY KX-PB - Transponder proximity device

Transponder proximity device only for 3.73 control panels

TECHNICAL SHEET

Supply voltage: 13.8 Vdc
Nominal current: 15 mA

Maximum current: 45 mA
Working frequency: 13.56MHz
Protocol: ISO & nbsp; & nbsp; 14443 & nbsp; Type & nbsp; A
Suitable for control units: X series and K series version x.73 or higher
Buzzer for sound input and output time
Signaling LED:

• Yellow LED : & Nbsp; & Nbsp; & Nbsp; programmable
• Red LED : & Nbsp; & Nbsp; & nbsp; programmable
• LED Orange: & nbsp; & nbsp; & nbsp; programmable
• Green LED : & Nbsp; & Nbsp; & Nbsp; programmable
• LED Courtesy bright red: recognized key & nbsp; & nbsp; & nbsp; & nbsp;

  Addressing dipswitch on the bus: dip in order 1-2-3

  • OFF OFF OFF = address 1
  • ON OFF OFF = address 2
  • OFF ON OFF = address 3
  • ON ON OFF = address 4
  • OFF OFF ON = address 5
  • ON OFF ON = address 6
  • OFF ON ON = address 7
  • ON ON ON = address 8

  Dip 4 anti-removal ability / disability (dip4 ON disabled)

  FASTENING

  - Open the wrapper unscrewing the screw on the lower side, and levering on the plastic tooth, taking care not to force.
  - Fasten the rear part to the wall by letting the cable out through the appropriate cable gland.
  - Set the addressing dip-switches according to the numerical setting required by your installation.

  - Connect the bus (A - B - positive - negative)
  - Close by resting the upper part of the cover by snapping the plastic tooth and screw in the locking screw.

  & nbsp;