CAME 3199ZBX-E24 Electronic card for BX-241 BX-E241 series motors

The control board must be powered at (230V a.c.) on terminals L1 and L2 and is protected at the input with a 1A fuse. The control devices are low voltage (24V), protected with a 1.6A fuse.
The total power of the 24V accessories must not exceed 40W. Working time is fixed at 90 seconds. The photocells can be connected and prepared for:
- Reopening during the closing phase;
- Partial stop: gate stop if in movement with consequent position for automatic closing;
-Total stop: this function stops the gate with the consequent exclusion of any automatic closing cycle; to resume the movement, use the push-button panel or the transmitter.
The card also integrates and independently manages a safety function sensitive to obstacles which: on opening: the gate stops and activates automatic closing; closing: the gate reverses the direction of travel until complete opening with consequent automatic closing. Other selectable functions:
-Auto lock. The automatic closing timer is self-powered at the end of the opening stroke. The pre-set adjustable time is in any case subject to the intervention of any safety accessories and is excluded after a total "stop" or in the absence of electricity; -Partial opening: desired gate opening for walkway adjustable by trimmer;
- Obstacle detection: this function cancels any command in the event of an obstacle detected by the photocells (connected in any safety function) with the gate at the end of its travel;
- "maintained action" operation;
- Pre-flashing on opening and closing;
- Type of command: open-stop-close-stop, open-close-inversion or only open.
Adjustments: automatic closing time, partial opening and adjustment of the amperometric sensitivity.